Unifi Protect Installation and configuration

This is part 2 of our on site camera job. In this video we run a few cables, mount some Unifi g4 bullet cameras and then I show you the configuration Amazon affiliates for gear I use: Brady BMP21 plus labeler: https://amzn.to/3kq0KkK Vertical cable I-Punch tool: https://amzn.to/3XxO6yu Vertical cable cat 6 vmax keystones: https://amzn.to/3Xk9xUa Monoprice 6 inch slim patch cables: https://amzn.to/3CQyRsH ▶ Hire us on our website https://mactelecomnetworks.com/ ▶ Discord Channel: https://discord.com/invite/nEaMr5zzkZ ▶ Find me on Twitch https://twitch.tv/frozil3 ▶Contact me on email: [email protected] ------------------------------------------------------------------------------------ Affiliates I use: ▶ VOIP.MS https://www.voip.ms/en/code/Mactelecom ▶Canadian Amazon Store front: https://www.amazon.ca/shop/mactelecomnetworks ▶USA Amazon store front: https://www.amazon.com/shop/mactelecomnetworks ------------------------------------------------------------------------------------ ▶ Find us on social media: ▶ Instagram: https://instagram.com/mactelecomnetworks ▶ Facebook: https://facebook.com/mactelecomnetworks ▶ Twitter: https://twitter.com/mactelecomn ▶ TikTok: https://www.tiktok.com/@mactelecomnetworks ▶ Linkedin: https://www.linkedin.com/in/cody-maccallum-29311b6b/ 0:00 Intro 0:26 runing cables 1:47 putting RJ45 end on cable and mounting camera inside 4:15 unmounting old cameras and mounting Unifi cameras 5:09 looking at the finished network rack 6:18 Creating a camera network and assigning vlans to ports 7:55 Creating firewall rules for the camera network 11:14 Locking port to camera mac address 11:53 camera high frame rate mode and detection zones 13:19 giving people access to your cameras 13:37 Final thoughts