Sketch Based Features CATIA Full in detail introduction

Hello dear friends, This video explains basic functions of the Sketch Based Features toolbar. Short description of tools is also given below. Pad Creating a pad means extruding a profile or a surface in one or two directions. The application lets you choose the limits of creation as well as the direction of extrusion. Pocket Creating a pocket consists in extruding a profile or a surface and removing the material resulting from the extrusion. The application lets you choose the limits of creation as well as the direction of extrusion. The limits you can use are the same as those available for creating pads. To know how to use them, see Up to Next Pads , Up to Last Pads , Up to Plane Pads, Up to Surface Pads. Shaft This task illustrates how to create a shaft, that is a revolved feature, by using an open profile. You need an open or closed profile, and an axis about which the feature will revolve. Groove Grooves are revolved features that remove material from existing features. This task shows you how to create a groove, that is how to revolve a profile about an axis (or construction line). Hole Creating a hole consists in removing material from a body. Various shapes of standard holes can be created. Rib This task shows you how to create a rib, that is how to sweep a profile along a center curve to create material. To define a rib, you need a center curve, a planar profile and possibly a reference element or a pulling direction. Slot This task shows you how to create a slot, that is how to sweep a profile along a center curve to remove material. To define a slot, you need a center curve, a planar profile, a reference element and optionally a pulling direction. Stiffner This task shows you how to create a stiffener by specifying creation directions. Hope you liked this video. Thankyou KapseTech