Retractable Roof Pergola "Star" - Installation

How to install Pergola Star , step by step 00:00 Mount the wall-brackets. 00:08 Mount the rafters onto the brackets and also the general regulator. 00:22 Assemble the parapet. 00:48 Mount the rafters onto the pillar. 01:13 Before placing the tube, end all the runners in the upper side of rafters. 01:20 Tube fitting. 01:29 Before placing the motor inside the tube, move a bit all the runners to the lower side of rafters. 01:40 Place the motor into the tube. Motor’s cables must be downside. 01:44 Place the restraint plate of the motor which you will find into the package. 02:00 Fit the support beam onto the cover material. Attention, the side of the support beams must be according to the enclosed sketch. 02:22 Stretch the cover material properly with the screws and the plugs that you will find into the package. 02:28 Pierce the cover material from one side to another, in the spots that the supports beams are already drilled. 02:34 Place the support beam onto the guides. 02:39 Repeat the procedure until the support beams placed onto the guides. 02:50 Place the last wide support beam onto the cover material and move all the support beams in the highest side of the guide. 03:08 Place the wide support beam onto the guides. 03:30 Open the Star pergola. 03:40 Open a small hole onto the cover material exactly above the beam that you will choose to have lights and then pull out a pair of cables. 03:50 Pass the cable through the plastic cap of the beam and connect it with the spo-light. 04:00 Connect the next spot-light with the cable that you will find enclosed. 04:09 Fasten the light onto the beam. 04:26 After fastening all lights, cover the cables with the special profile. 04:33 Repeat the same procedure for the other beams that will have lightning system. 04:42 Place the parapet and support beam plugs. 04:54 Install the rear profile into the blades of rafters and then adjust the aluminum cover in it. 05:12 Put the iron blades into the front profile and screw it onto the drivers after you adjust the aluminum cover in it. 05:59 Adjust the motor limits. 06:04 Pergola Star has been successfully installed. http://www.metaform.gr/products/star?&lang=en