Mini Lathe Carriage Saddle Clamp Upgrade - with ball bearings + bonus vinyl cutting project

This video is how I upgraded the carriage clamps to use individually adjustable ball bearings on the MINI LATHE. (MUCH) More information below! Please like and subscribe if this was helpful! Stuff from this video: Transfer Punches: http://amzn.to/2pQ4oGi Set Screws: http://amzn.to/2q9YgcZ Loctite: http://amzn.to/2ps8Mes Tap and Die Set: http://amzn.to/2pBk6SB Vinyl Cutter: http://amzn.to/2pQNLZg Vinyl: http://amzn.to/2qCprgC Lathe: https://amzn.to/2nVBrEc Stuff on the lathe: Quick Change Tool Holder: https://amzn.to/2oZtFee Tailstock Drill Chuck: https://amzn.to/2pmE0jX Lathe tools: Boring Bar: https://amzn.to/2pmy0b1 Carbide Tools: https://amzn.to/2oRZWax Parting Tool: https://amzn.to/2nVCeW1 Center Bits: https://amzn.to/2oRRV5n Drill Bits: http://amzn.to/2oz9W76 Other stuff: Cutting oil: http://amzn.to/2ofkPaY Mini Lathe troubleshooting guide: http://littlemachineshop.com/reference/drivetroubleshooting.pdf Controller board wiring configuration: http://imgur.com/KIEzu92 The real version of the motor controller: https://amzn.to/2orw43F Datasheet for the KBIC-120: https://www.galco.com/buy/KB-Electronics/KBiC-120 Super nice guy who repairs the controller boards: http://olduhfguy.com/ Music: https://soundcloud.com/jeff-kaale https://soundcloud.com/andrewapplepie https://soundcloud.com/dyallas https://soundcloud.com/maxzwell https://soundcloud.com/joakimkarud