Learning to Install DCC Concepts Cobalt IP Digital Point Motors, Dropper Wires & Power Bus | Ep. 6 🚂🔧
Welcome back! I’m The Novice Railway Modeller, and this is my fifth full update as I attempt to build my first-ever model railway—mistakes, challenges, and all!
In this episode, I take on another learning curve:
✅ Installing five DCC Concepts Cobalt IP Digital Point Motors
✅ Wiring dropper wires to the track
✅ Adding two Power Buses
It’s a journey full of problems, troubleshooting, and lessons learned. If you're an experienced modeller, I’d love your tips and advice—drop a comment below!
💬 Got any tips on wiring, soldering, or trackwork? Let me know in the comments!
📌 Subscribe for more model railway learnings, mistakes, and behind-the-scenes progress as I build Sandale Model Railway → UCz2DBpD8BhCxTiYbQKEe6SA
00:00 Introduction
00:12 Preamble
01:28 Another Broken Frog Wire
05:49 Preparing the First Point Motor for Installation
09:30 Installing the First Point Motor
14:24 Spring has Arrived
19:30 I need to rip up a point motor and turn it around
21:48 Finding a Dead Point Motor!
23:11 Introducing 2x Power Bus
24:56 A discussion about the right DCC controller for me
28:44 Introducing Terminal Block Connectors
31:29 Test Run of the Class 08 Shunter across the point network
37:09 Wrapping up this update
Check out my play list of Building the layout infrastructure
https://youtube.com/playlist?list=PL9CR__Dcf2gDfxsuf6SlbKa-jYpoHTEeU&si=Mrz03Gi7cxrrX-f2
Once viewed please catch up with my other video updates
https://youtu.be/i4PNMuAwZrA?si=PwKopVyMw-r0dHrW
https://youtu.be/_tLrPmcuE7M?si=EkTlEMc_P52mrvmN
https://youtu.be/IEBgq09TPgc?si=xDr-BDHmjgvJTkZ3
https://youtu.be/vcBJ4FBxDPs?si=JisFXlJxIuAILhxu
📲 Follow my daily updates on:
🔹 TikTok → https://www.tiktok.com/@novice_railway_modeller?is_from_webapp=1&sender_device=pc
🔹 Instagram → https://www.instagram.com/sandale.railway
#ModelRailway #RailwayModelling #ModelTrains #DCCConcepts #CobaltIP #ModelRailroad #Trackwork #DCC #TrainLayout