Calibrating a Haas Probe and Tool Setter on a CHC Controller (Pre NGC)

I purchased a WIPS (Wireless Intuitive Probing System) probe and tool setter from Haas. Because my machine is a 2009 machine, and therefore has the CHC (Classic Haas Controller), there is a lot less information out there about calibrating the probe. Plus, because of the tight installation, they had to angle it at 45 degrees. VQC Instructions: https://www.haascnc.com/service/troubleshooting-and-how-to/how-to/mill---probing-with-vqc-templates.html Tool Probe Mount: https://exactengineeringshop.com/collections/tool-probe-mount/products/renishaw-ots-rts-tool-probe-mounting-system